this SIM5218 AT command manual - Cooking Hacks

SIM5218 Serial AT Command Set
Syntax
Test Command
AT+AUTOANSWER=
Read Command
AT+AUTOANSWER
Write Command
AT+AUTOANSWER=
[,]
Responses
+AUTOANSWER: (list of supported s), (list of supported
s)
OK
Responses
+AUTOANSWER: ,
OK
Responses
OK
Defined values
0 – disable auto answer
1 – enable auto answer
0 – use current PORT(read for other value, refer to notes)
1 – use UART port to output URCs
2 – use MODEM port to output URCs
3 – use ATCOM port to output URCs
NOTE 1. If subparameter is omitted, the current port will be used.
2. If subparameter is zero, read for current port index, it’s not zero.
3. If subparameter is not zero and auto answer is eanbled, the corresponding port
should be opened when data call incoming.
Examples
AT+AUTOANSWER=1,1
OK
AT+AUTOANSWER
+AUTOANSWER: 1,1
OK
4.24 ATS0 Automatic answer
Description
The S-parameter command controls the automatic answering feature of the Module. If set to 000,
automatic answering is disabled, otherwise it causes the Module to answer when the incoming call
indication (RING) has occurred the number of times indicated by the specified value; and the
setting will not be stored upon power-off, i.e. the default value will be restored after restart.
SIM5218_Serial _ATC_V1.36 63
5/15/2012