this SIM5218 AT command manual - Cooking Hacks

SIM5218 Serial AT Command Set
string type. The string is given as dot-separated numeric (0-65535) parameters on the form "f.t".
numeric value in hexadecimal format. The value range is from 00000000 to FFFFFFFF.
string type. The string is given as dot-separated numeric (0-255) parameters on the form "t.m".
numeric value in hexadecimal format. The value range is from 00000 to FFFFF. Valid for IPv6 only.
a numeric parameter which specifies the transmission direction in which the packet filter shall be
applied.
0 Pre-Release 7 TFT filter (see 3GPP TS 24.008 [8], table 10.5.162)
1 Uplink
2 Downlink
3 Birectional (Up & Downlink)
Examples
AT+CGTFT
+CGTFT: 2,1,0,"74.125.71.99.255.255.255.255",0,0.0,0.0,0,0.0,0
OK
AT+CGTFT=2,1,0,"74.125.71.99.255.255.255.255"
OK
AT+CGTFT=
+CGTFT: "IP",(1-2),(0-255),,(0-255),(0-65535.0-65535),(0-65535.0-65535),(0-FFFFF
FFF),(0-255.0-255),(0-FFFFF)
+CGTFT: "PPP",(1-2),(0-255),,(0-255),(0-65535.0-65535),(0-65535.0-65535),(0-FFFF
FFFF),(0-255.0-255),(0-FFFFF)
+CGTFT: "IPV6",(1-2),(0-255),,(0-255),(0-65535.0-65535),(0-65535.0-65535),(0-FFF
FFFFF),(0-255.0-255),(0-FFFFF)
OK
18.4 AT+CGQREQ Quality of service profile (requested)
Description
The command allows the TE to specify a Quality of Service Profile that is used when the MT sends
an Activate PDP Context Request message to the network.. A special form of the set command
(AT+CGQREQ=) causes the requested profile for context number to become
undefined.
SIM PIN References
YES 3GPP TS 27.007
SIM5218_Serial _ATC_V1.36 320
5/15/2012