this SIM5218 AT command manual - Cooking Hacks

SIM5218 Serial AT Command Set
being set up.
VPRINGBACK
VPSETUP
VPCONNECTED
VPEND[: ]
MISSED_VIDEO_CALL: ,
+VPRXDTMF:
Indicate that remote party (other side) is
located and ringing.
Indicate that video call is set up end-to-end.
Indicate that video protocols are set up and
video call is connected.
Indicate that video call has ended.
is the duration of video call, from
VPCONNECTED to VPEND and the unit is
in second.
Indicate that an incoming video call is missed.
denotes when this indication is
reported, and the format is yy/MM/dd,hh/mm
/ss, where characters indicate year (two
last digits), month, day, hour, minutes,
seconds.
is caller’s phone number.
Indicate that a user input was received from
remote party.
is DTMFs tone from remote
party, and consisted of (0-9, *, #).
NOTE DTMFs are sent as an H.245 User Input
Indication message (basic string).
28.5.2 Call flows – video call origination
Commands and Responses
AT+VPSOURCE=2,”pic.jpg”
OK
AT+VPRECORD=3
OK
AT+VPMAKE=”123456789”
VPACCEPT
OK
VPRINGBACK
VPSETUP
VPCONNECTED
AT+VPRECORD=0
OK
AT+VPSOURCE=1
Comments
Set TX source
Start recording video
Make video call
Stop recording video
Switch TX source
SIM5218_Serial _ATC_V1.36 514
5/15/2012