PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECTION 5<br />
CAUTION<br />
Maintenance<br />
Over tightened Parts Will Be Difficult To<br />
Disassemble And May Damage <strong>Torch</strong>.<br />
Do not over tighten parts during<br />
reassembly.<br />
Threaded parts are designed to work properly<br />
when hand tightened, approximately 40 to 60<br />
inch/pounds<br />
5.4 Assembly Of <strong>Torch</strong> Front End<br />
• Reverse order of disassembly.<br />
• Apply a thin coat of silicone grease,<br />
P/N 77500101 to O-rings before assembling<br />
mating parts. This will facilitate disassembly in<br />
the future.<br />
• Hand-tighten threaded parts.<br />
• Installing the electrode requires only moderate<br />
hand tightening. Electrode holder should always<br />
be made tighter than the electrode.<br />
Nozzle<br />
NOTE: When assembling, place the nozzle<br />
inside the nozzle retainer and thread the<br />
retainer/nozzle combination on the torch body.<br />
This will help align the nozzle with the assembly.<br />
Nozzle Retainer<br />
5-5
Change language