PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION 3<br />
INSTALLATION<br />
3.4 Mounting <strong>Torch</strong> to Machine<br />
Refer to machine manual.<br />
!<br />
WARNING<br />
Clamping on <strong>Torch</strong> Body May Cause<br />
Dangerous Current To Flow Through<br />
Machine Chassis.<br />
• Do not mount on stainless steel torch<br />
body.<br />
Mount torch on<br />
insulated sleeve<br />
here<br />
C<br />
DO NOT mount<br />
on steel torch<br />
body here<br />
AUTION: CLAMP TORCH ABOVE THIS LA<br />
<strong>PT</strong>-<strong>600</strong><br />
PLASMARC TORCH<br />
BEL<br />
• <strong>Torch</strong> body is electrically insulated,<br />
however high frequency start current may<br />
arc through to find a ground.<br />
• Clamping near torch body may result in<br />
arcing between body and machine.<br />
• When this arcing occurs, torch body may<br />
require non-warranty replacement.<br />
• Damage to machine components may<br />
result.<br />
• Clamp only on insulated torch sleeve not<br />
less than 1.25" (31.75mm) from the torch<br />
end of the sleeve.<br />
3-4
Change language