PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECTION 4<br />
<strong>PT</strong>-<strong>600</strong> Process Data<br />
200 Amperes<br />
Aluminum<br />
OPERATION<br />
Except where noted, data is for above water<br />
cutting. Reduce speed approximately 10% when<br />
cutting under water.<br />
Start<br />
Gas<br />
Cut<br />
Gas<br />
Shield<br />
Gas<br />
Material Thickness Air Air Air<br />
Timers<br />
IN 0.250 0.313 0.375 0.500 0.625 0.750 1.000<br />
MM 6,4 7,9 9,5 12,7 15,9 19,1 25,4<br />
Rise On Pierce (sec.) 0 0.1 0.1 0.2 0.2 0.2 0.3<br />
Pierce Delay (sec.) 0.2 0.2 0.3 0.3 0.3 0.5 0.6<br />
Setup Parameters Pounds per Square Inch (PSI - Pressure)<br />
<strong>Plasma</strong> Start Gas<br />
<strong>Plasma</strong> Cut Gas<br />
Shield Start Gas<br />
Shield Cut Gas<br />
Height Readings<br />
Travel Speed<br />
Kerf Width<br />
Notes:<br />
Pilot Arc Set to High<br />
Initial Height<br />
PSI 25 25 25 25 25 25 25<br />
BAR 1,7 1,7 1,7 1,7 1,7 1,7 1,7<br />
PSI 44 44 44 44 44 44 44<br />
BAR 3,0 3,0 3,0 3,0 3,0 3,0 3,0<br />
PSI 14 14 14 14 14 14 14<br />
BAR 1,0 1,0 1,0 1,0 1,0 1,0 1,0<br />
PSI 15 15 15 15 15 15 15<br />
BAR 1,0 1,0 1,0 1,0 1,0 1,0 1,0<br />
IN. .375 .375 .375 .500 .500 .500 .500<br />
MM 9,5 9,5 9,5 12,7 12,7 12,7 12,7<br />
Arc Voltage (standoff) 155 160 160 167 170 175 186<br />
IPM 125 125 110 85 70 60 40<br />
MM/MIN 3175 3175 2794 2159 1778 1524 1016<br />
Inches .110 130 .130 .130 .140 .140 .140<br />
Millimeters 2,8 3,3 3,3 3,3 3,6 3,6 3,6<br />
4-41