PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
PT-600 Mechanized Plasma Cutting Torch
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION 4<br />
!<br />
WARNING<br />
OPERATION<br />
Oil And Grease Can Burn Violently!<br />
• Never use oil or grease on this torch.<br />
• Handle torch clean hands only on clean<br />
surface.<br />
• Use silicone lubricant only where directed.<br />
• Oil and grease are easily ignited and burn<br />
violently in the presence of oxygen under<br />
pressure.<br />
4.1 Set Up<br />
• Select an appropriate condition from the<br />
process data (SDP File) and install<br />
recommended torch front-end parts (nozzle,<br />
electrode, etc.) See process data to identify<br />
parts and settings.<br />
• Position torch over material at desired start<br />
location.<br />
• See Power Source Manual for proper settings.<br />
• See Flow Control Manual for gas control<br />
procedures.<br />
• See Control and Machine Manuals for startup<br />
procedures.<br />
4.1.1 Mirror <strong>Cutting</strong><br />
When mirror cutting, a reverse swirl gas baffle and<br />
reverse diffuser are required. These reverse parts<br />
will “spin” the gas in the opposite direction,<br />
reversing the “good” side of the cut.<br />
Reverse 4 Hole Baffle 0558002534<br />
Reverse 8 Hole Baffle 0558002530<br />
Reverse 32 Hole Baffle 0558002531<br />
Reverse Diffuser 22496<br />
4-2
Change language