DLI Implementation and Reference Guide - Datalogics

DLI Reference Guide A.129
Xint1/
Yint1
X1/Y1
Xint2/
Yint2
Current Position
X2/Y2
Technical Notes
1 The two lines (CurrX,CurrY)->(X1,Y1) and (X2,Y2)->(X1,Y1) are joined by an
arc of radius (Rad). The line segment from the current position to the start of the
arc is drawn, followed by the arc itself, finishing at (Xint2,Yint2). The line
segment from the end of the arc to the point (X2,Y2) is not drawn.
2 The position following this command will be the intersection of the arc with the
line (X2,Y2)->(X1,Y1), shown above as (Xint2,Yint2). If the two lines are
colinear, a straight line segment is drawn from the current position to (X1,Y1),
which then becomes the current point.