TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH
TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH
TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6 Configuring the <strong>TAINY</strong> <strong>GMOD</strong>-Sx<br />
Configuring the <strong>TAINY</strong> <strong>GMOD</strong>-Sx<br />
Procedure During the configuration a variety of configuration data must be<br />
selected or entered. To make sure that you have this information at<br />
hand during the configuration the best way to proceed is as follows:<br />
1. First collect and note down the configuration data using the<br />
configuration table (see page 38 ff).<br />
2. Only when you have completely filled in the configuration table<br />
should you perform the actual configuration. You configure the<br />
<strong>TAINY</strong> <strong>GMOD</strong>-Sx using the configuration program<br />
<strong>TAINY</strong> <strong>GMOD</strong>-SxConfig – see below.<br />
Remote<br />
configuration<br />
The <strong>TAINY</strong> <strong>GMOD</strong>-Sx may be configured from a remote station –<br />
see Remote configuration on page 69.<br />
6.1 Performing the Configuration locally<br />
Prerequisites • The service PC is connected to the interface COM of the<br />
<strong>TAINY</strong> <strong>GMOD</strong>-Sx.<br />
• The configuration program <strong>TAINY</strong> <strong>GMOD</strong>-SxConfig is installed<br />
on the service PC and the following have been installed<br />
- the driver for connecting to the <strong>TAINY</strong> <strong>GMOD</strong>-Sx in service<br />
mode.<br />
- the dial-up connection for service of the device.<br />
• You have filled in the configuration table (page 38 ff.) so that<br />
you have the necessary configuration data at hand.<br />
Executing the<br />
configuration<br />
program<br />
To do this proceed as follows:<br />
1. Switch the <strong>TAINY</strong> <strong>GMOD</strong>-Sx to service mode by pressing the<br />
service button for a minimum of 1 second but no longer than 3<br />
seconds<br />
� The LEDs S, Q and C blinking slowly and synchronously<br />
indicate that the <strong>TAINY</strong> <strong>GMOD</strong>-Sx is operating in service<br />
mode.<br />
2. Execute the configuration program. Start it as follows insofar as<br />
the specifications have been taken over during installation of<br />
this program:<br />
Menu Start, Programs, <strong>Neuhaus</strong>, <strong>TAINY</strong> <strong>GMOD</strong>-Sx, <strong>TAINY</strong><br />
<strong>GMOD</strong>-SxConfig<br />
<strong>TAINY</strong> <strong>GMOD</strong>-Sx 37 von 84