TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH
TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH
TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Parameter Explanation, configuration options<br />
[COM2]<br />
BAUDRATE<br />
[COM2]<br />
FORMAT<br />
Configuring the <strong>TAINY</strong> <strong>GMOD</strong>-Sx<br />
interface answers the call with the command ATA – see COM<br />
interface: AT commands supported in CS mode, page 78.<br />
This requires that the <strong>TAINY</strong> <strong>GMOD</strong>-Sx be set to Dial-up<br />
connection mode (CS), see page 42.<br />
� An existing GPRS connection, i.e. to the <strong>TAINY</strong><br />
SwitchingCenter, will be interrupted when a GSM data call<br />
comes in.<br />
Afterwards the GPRS connection will be restored if<br />
<strong>TAINY</strong> <strong>GMOD</strong>-Sx is set to Leased line mode (LL). If DTR is<br />
selected for Control in connection mode Leased line (LL), the<br />
DTR signal has to be active.<br />
<strong>TAINY</strong> <strong>GMOD</strong>-S2:<br />
� The following parameters only apply for the <strong>TAINY</strong> <strong>GMOD</strong>-S2.<br />
Furthermore, they are only active if the device is configured<br />
such that incoming GSM data calls shall be routed to COM2<br />
(see configuration tab CSD Transparent, page 55).<br />
Baud rate:......................................................................................<br />
(Default: 57600) Defines the speed with which the <strong>TAINY</strong><br />
<strong>GMOD</strong>-S2 communicates with the application connected to its<br />
interface COM2.<br />
Permissible values: 300, 1200, 2400, 4800, 9600, 19200,<br />
38400, und 57600.<br />
If you want to change the value use the selection list.<br />
� The value set here must match the speed with which the<br />
connected application can communicate.<br />
Character format:..............................................................................<br />
Default: 8N1 (= 8 data bits, non parity, 1 stop bit)<br />
Defines the character format with which the <strong>TAINY</strong> <strong>GMOD</strong>-S2<br />
communicates with the application connected to its COM2 port.<br />
Permissible values:<br />
7N1, 8E1, 7E1, 8O1, 7O1, 8N2, 7N2, 8E2, 7E2, 8O2, 7O2, 8N1<br />
If you want to change the value use the selection list.<br />
� The value set here must match the speed with which the<br />
connected application can communicate.<br />
<strong>TAINY</strong> <strong>GMOD</strong>-Sx 49 von 84