TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH

Configuring the TAINY GMOD-Sx
Parameter Explanation, configuration options
service.
Permissible values: max. 30 characters, digits 0 to 9, +, *
* denotes that all incoming GSM data calls are accepted as
service calls.
� TAINY GMOD-Sx first checks if an incoming GSM data call is
admissible for remote service. Only if the remote station is not
specified for service access does it check if the call is
permissible for the COM interface. Therefore, please make
sure that phone numbers specified for COM access have not
already been configured for service access and vice versa
� If you specify *(Star) as remote service phone number, no
GSM data call is routed to the COM interface for data transfer
with the application. All incoming GSM data calls are then
interpreted as service calls.
� GSM data calls for remote service differ from those specified in
CSD Transparent. For remote service of the TAINY GMOD-Sx
the data are exchanged packet oriented via the GSM network
or GSM/PSTN using the TCP/IP protocol. When using a
remote station with Windows operating system, the dial-up
network connection has to be used for service calls – also see,
PPP (Point-to-point protocol) in the section Glossary.
� An existing GPRS connection, i.e. to the TAINY
SwitchingCenter, will be interrupted when a GSM data call
comes in.
Afterwards the GPRS connection will be restored if
TAINY GMOD-Sx is set to Leased line mode (LL). If DTR is
selected for Control in connection mode Leased line (LL), the
DTR signal has to be active.
60 von 84 TAINY GMOD-Sx