TAINY GMOD - Dr. Neuhaus Telekommunikation GmbH

Parameter Explanation, configuration options
LINE=LL
LINE=CS
Configuring the TAINY GMOD-Sx
Connection mode
� Leased line mode (LL)
If a connection shall be set up without control by the application
or if the TAINY GMOD-Sx is controlled by the connected
application by DTR, select the Leased line mode (LL). This
mode is supported by all three server types: TAINY
SwitchingCenter, TAINY ModemServer and TAINY
ComPortServer.
� Dial-up connection mode (CS)
If the TAINY GMOD-Sx is controlled by the connected
application by AT commands (like a conventional modem) so
that it can establish dial-up connections via the TAINY
SwitchingCenter / TAINY ModemServer, select the Dial-up
connection mode (CS).
In this dial-up connection mode, the device establishes the
connection to the TAINY SwitchingCenter / ModemServer as
soon as the operating voltage is applied. The “logical”
connection to the respective TSC terminal device is
established with an AT dial command.
TAINY GMOD-Sx will release the logical connection after a
timeout or when receiving “+++” followed by “ATH”. The
physical connection to the TAINY SwitchingCenter /
ModemServer will be continued.
The AT commands supported in this mode are given in the
section COM interface: AT commands supported in CS
mode, page 78.
� Please note that data packets exchanged for setting up
connections, reconnecting, connect attempts (e.g. Server
switched off, wrong destination address, etc.) as well as
keeping the connection alive are also subject to charge.
TAINY GMOD-Sx 45 von 84