AT Commands Manual - Teltonika

More documents

Recommendations

Info

AT CommandsUser ManualTest commandAT+CSSN=?+CSSN: (list of supported s),(list of supported s)OK this parameter sets/shows the +CSSI result code presentation status in the TA and may be:− 0: disable.− 1: enable. this parameter sets/shows the +CSSU result code presentation status in the TA and may be:− 0: disable.− 1: enable. may be:− 0: unconditional call forwarding is actine.− 1: some of the conditional call forwardings are actine.− 2: call has been forwarded.− 3: call is waiting.− 4: this is a CUG call (also present).− 5: outgoing calls are barred.− 6: incoming calls are barred.− 7: CLIR suppression rejected.− 8: calls has been deflected. refer +CCUG. may be:− 0: this is a forwarded call (MT call setup).− 1: this is a CUG call ( present) (MT call setup).− 2: call has been put on hold (during a voice call).− 3: call has been retrieved (during a voice call).− 4: multiparty call entered (during a voice call).− 5: cal on hold has been released – not a SS notification – (during a voice call).− 6: forward check SS message received (can be received whenever).− 7: call is being connected (alerting) with the remote party in alerting state in explicit call transferoperation (during a voice call).− 8: call has been connected with the other remote party in explicit call transfer operation (during a voicecall or MT call setup).− 9: this is a deflected call (MT call setup).− 10: additional incoming call forwarded. string type phone of format specified by . type of address octet in integer format., not used.11.14 Unstructured supplementary service data +CUSDCommand syntaxDescriptionAT+CUSD=,, This command allows control of the Unstructured Supplementary Service Data (USSD)according to GSM02.90. Both network and mobile initiated operations are supported.Parameter is used to disable/enable the presentation of an unsolicited result code+CUSD: [,,] to the TE. Value =2 is used to cancel an ongoingUSSD session. This command is abortable (proprietary feature). When is given, amobile initiated USSD-string or a response USSD-string to a network initiated operationis sent to the network. The response USSD-string from the network is returned in theunsolicited +CUSD result code indicated above.AT+CUSD=1,”*100#”,15Read commandAT+CUSD?+CUSD: 2,”Residual credit: 7,87 Euro”,15OKorCME ERROR: +CUSD: OK48
AT CommandsUser ManualTest commandAT+CUSD=?+CUSD: (list of supported s)OK may be:− 0: disable the result code presentation in the TA.− 1: enable the result code presentation in the TA.− 2: cancel session (not applicable to read command response). sting type USSD-string converted in the selected character set. data coding scheme. may be:− 0: no further user action required.− 1: further user action required.− 2: USSD termination by network.− 4: operation not supported.− 5: network time out.11.15 Closed user group +CCUGCommand syntaxDescriptionAT+CCUG=,, This command enables subscribers to form closed user groups to and from whichaccess is restricted (GSM02.85). The command can be used to:activate/deactivate the control of the CUG information for all following calls selecta CUG index suppress the outgoing access (OA). The OA allows a member of aCUG to place calls outside the CUG suppress the preferential CUG.Read commandAT+CCUG?Test commandAT+CCUG=?AT+CCUG=1,2,1OKorCME ERROR: +CCUG: ,,OKOK may be:− 0: disable CUG temporary.− 1: enable CUG temporary. may be:− 0 ... 9 CUG index.− 10 no index (preferred CUG taken from subscriber data). may be:− 0: no information.− 1: suppress OA.− 2: suppress preferential CUG.− 3:suppress OA and preferential CUG.49
Page 7 and 8: AT CommandsUser Manual1 Introductio
Page 9 and 10: AT CommandsUser Manual4 General com
Page 11 and 12: AT CommandsUser Manual5 Mobile equi
Page 13 and 14: AT CommandsUser Manual5.6 Display c
Page 15 and 16: AT CommandsUser Manual− 1: indica
Page 17 and 18: AT CommandsUser Manual may be− 17
Page 19 and 20: AT CommandsUser Manual5.17 Call met
Page 21 and 22: AT CommandsUser Manual6 Call Contro
Page 23 and 24: AT CommandsUser ManualCommand synta
Page 25 and 26: AT CommandsUser Manual7 Network Ser
Page 27 and 28: AT CommandsUser Manual7.4 Network r
Page 29 and 30: AT CommandsUser Manual8 Security Co
Page 31 and 32: AT CommandsUser Manual9 Phonebook C
Page 33 and 34: AT CommandsUser Manual10 Short Mess
Page 35 and 36: AT CommandsUser Manual may be:− 0
Page 37 and 38: AT CommandsUser Manual10.9 Read mes
Page 39 and 40: AT CommandsUser Manual10.13 Write m
Page 41 and 42: AT CommandsUser Manual11 Supplement
Page 43 and 44: AT CommandsUser Manual string type
Page 45 and 46: AT CommandsUser Manual11.6 Advise o
Page 47: AT CommandsUser ManualAT+CTFR=? is
Page 52: AT CommandsUser Manualservice will
Page 57 and 58: AT CommandsUser Manual13.17 Call te
Page 59 and 60: AT CommandsUser Manual may be in ra
Page 61 and 62: AT CommandsUser Manual14 V24 contro
Page 63 and 64: AT CommandsUser ManualCME ERROR: 14
Page 65 and 66: AT CommandsUser Manual may be:− 0
Page 67 and 68: AT CommandsUser Manual is in range
Page 69 and 70: AT CommandsUser Manual15 Specific A
Page 71 and 72: AT CommandsUser Manual: Channel mod
Page 73 and 74: AT CommandsUser Manual- 2: dialing
Page 75 and 76: AT CommandsUser Manual15.11 Configu
Page 77 and 78: AT CommandsUser ManualSIM ToolkitTh
Page 79 and 80: AT CommandsUser Manual may be (deci
Page 83 and 84: AT CommandsUser Manual- 0 detached.
Page 85 and 86: AT CommandsUser ManualAT+CGATT?Test
Page 87 and 88: AT CommandsUser Manual16.11 GPRS mo
Page 89 and 90: AT CommandsUser Manual17 Appendices
Page 91 and 92: AT CommandsUser Manual16 normal cal

AT Commands Manual - Teltonika

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?