AT Commands Manual - Teltonika

AT CommandsUser ManualCME ERROR: 14.9 Designate a default reset profile &YCommand syntaxDescriptionAT&YThis command selects which user profile will be used after a hardware reset. The settingswhich may be changed are described in the chapter related to the &V command. An error isreturned if the parameter is greater then 2 or NVRAM is not installed or is notoperational.AT&Y1OKorCME ERROR: may be:− 0: selects profile 0.− 1: selects profile 1.− 2: selects the default factory settings.14.10 Request identification information ICommand syntaxDescriptionATIATI3 Manufacturer 3OKorCME ERROR: This action command causes the DCE to transmit one or more lines of information text,determined by the manufacturer, followed by a final result code. may be in range 0-9; for each value an other text provided by the manufacturer will be displayed.14.11 Request manufacturer Identification +GMICommand syntaxDescriptionAT+GMIThis action command causes the DCE to transmit one or more lines of information text,determined by the manufacturer, which allows to identify the manufacturer.AT+GMI 5OKorCME ERROR: Test commandOKAT+GMI=?14.12 Request model identification +GMMCommand syntaxDescriptionAT+GMM 6This command gives the model identification.Test commandOKAT+GMM=?14.13 Request revision identification +GMRCommand syntaxDescriptionThis command gives the revised version of the mobile station.AT+GMROKorCME ERROR: 5 get manufacturer identification.6 get model identification.63