AT Commands Manual - Teltonika
AT Commands Manual - Teltonika
AT Commands Manual - Teltonika
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>AT</strong> <strong>Commands</strong>User <strong>Manual</strong>- or the input is terminated with a character not equal to a hex digit or .The session is terminated by default with +++, the context is deactivated. If ct108 (<strong>AT</strong>&D) is equal to 2and the selected L2 protocol is "M-HEX", the channel is switched back to idle mode but the context remainsactivated. Leave the layer 2 packet protocol by typing of +++.16.9 Automatic response to a network request for PDP context activation+CGAUTOCommand syntaxDescription<strong>AT</strong>+CGAUTO= This set command disables or enables an automatic positive response (auto-answer) to thereceipt of a Request PDP context activation message from the network. The setting S0 isused as usual, but related to the GPRS incoming request. The A or H command handlingmay be used in order to accept or reject a network PDP request for PDP activation. Thesetting +CGAUTO does not affect the issuing of the unsolicited result code RING or+CRING.If the parameter allows an positive answer to the network request for PDP contextactivation, the MT shall initiate an attach if it is not already attached.<strong>AT</strong>+CGAUTO=1OKorCME ERROR: Read command+CGAUTO: <strong>AT</strong>+CGAUTO?OKTest command+CGAUTO: (list of the supported s)<strong>AT</strong>+CGAUTO=?OK may be:- 0: turn off automatic response for GPRS only; in this case network requests are only manually acceptedor rejected;- 1: turn on automatic response for GPRS only; in this case network requests are automatically accepted.- 2: modem compatibility mode, GPRS only; the automatic acceptance is controlled by the S0 setting;manual control using the A, +CGANS or H command is possible; incoming circuit switched calls can beneither manually nor automatically answered;- 3: modem compatibility mode, GPRS and circuit switched calls (default); automatic acceptance of bothGPRS network requests and incoming circuit switched calls is controlled by the S0 setting; A, +CGANSand H commands are also usable; not only GPRS but also circuit switched calls are also handled.16.10 Show PDP address +CGPADDRCommand syntax<strong>AT</strong>+CGPADDR=,,...DescriptionThis execution command returns a list of PDP addresses for the specified contextidentifiers.<strong>AT</strong>+CGPADDR= +CGPADDR: 1,”1.2.3.4”i.e.+CGPADDR: ,[+CGPADDR: ,...OKorCME ERROR: Test command<strong>AT</strong>+CGPADDR=?+CGPADDR: (list of defined s)OK86
Change language