AT Commands Manual - Teltonika

AT CommandsUser Manual is in range 1-255.14.26 Command dial modifier time S8Command syntaxDescriptionThis command specifies the amount of time in seconds, which the DCE shall pause, duringATS8= dialing, when a “,” dial modifier is encountered in a dial string.The command has no effect.ATS8=4OKorCME ERROR: Read command004ATS8?OK is in range 0-255.14.27 Automatic disconnect delay S10Command syntaxDescriptionThis command specifies the amount of time in tenth of a second, which the DCE willATS10=remain connected to the line after the DCE has indicated the absence of received line signal.The command has no effect.ATS10=30OKorCME ERROR: Read command030ATS10?OK is in range 1-254.14.28 Escape prompt delay (EPD) S12Command syntaxDescriptionThis command defines the maximum period, in fiftieths of a second, allowed betweenreceipt of the last character of the three escape character sequence from the DTE andATS12=sending of the OK result code to the DTE. If any characters are detected during this time,the OK will not be sent.ATS12=80OKorCME ERROR: Read command080ATS12?OK is in range 0-255 1/50 of a second; default: 50 (1 second).14.29 Command echo ECommand syntaxDescriptionThis command controls whether or not the TA echoes characters received from the DTEATEduring command state.ATE1OKorCME ERROR: may be:− 0: echo off.− 1: echo on.14.30 Result code suppression QCommand syntaxDescription67