AT Commands Manual - Teltonika

AT CommandsUser Manual indicates help requested and may be:− 1: help is requested.− 0: help is not requested. currently used language in the DTE (coding see 11.14). indicates command code related parameters as follows:− for code 211 (hexa D3): .− for code 214 (hexa D6): .15.20 SIM-APPL-TK terminal profile +STKPROFCommand syntaxDescriptionAT+STKPROF=, This command allows reading and changing the terminal profile data. The terminal profilesent by an external STK client state the facilities relevant to SIM Application Toolkit that aresupported.AT+STKPROF=4,”1F7F” OKorCME ERROR: AT+STKPROF?Test commandAT+STKPROF=?+STKPROF: , e.g. +STKPROF=4,”1F7F”OKOK: integer type value; length of the characters that are sent to TE in .Note: set to 0 forces a reset to the default terminal profile stored in the ME.: terminal profile data coded in hex format.15.21 SIM-APPL-TK call control commands +STKCCDescriptionThe SIMAP call control status is displayed using the unsolicited result code +STKCC: ,… defined as:+STKCC: 1,,,+STKCC: 2,,,+STKCC: 3,,,+STKCC: 4,,,,,, may be:− 1: set up call.− 2: send SS.− 3: send USSD.− 4: send SM. call control result value. text string. called party number. type of number and numbering plan. service centre address. destination address.15.22 SIM-APPL-TK proactive session status +STKCNFDescriptionThe SIMAP proactive session status is displayed using the unsolicited result code STKCNF:, , , . decimal code indicates the command that was finished (refer +STKPRO). general result code. additional result code.80