AT Commands Manual - Teltonika

AT CommandsUser Manual may be in range 0-1.13.31 Selective polling address +FPACommand syntaxDescriptionAT+FPA=contained in the +FPA at the times specified in T.30, if the corresponding parameter is notzero string. 20 digit string; valid values 0-9, *, #, space13.32 Local polling ID string +FPICommand syntaxDescriptionAT+FLI=Polling is not supported. only zero string; polling is not supported.13.33 Packet protocol control +FPPCommand syntaxDescriptionAT+FPP= This command allows to control the packet protocol. The packet protocol is not supported. only value 0 allowed.13.34 Page status +FPSCommand syntaxDescriptionAT+FPS=This parameter contains a value representing the post age response, including copy qualityand related end-of-page status. may be:− 1: MCF, page good.− 2: RTN, page bad; retrain requested.− 3: RTP, page good; retrain requested.− 4: PIN, page bad; interrupt requested.− 5: PIP, page good; interrupt requested.13.35 Password parameter +FPWCommand syntaxDescriptionAT+FPW=This parameter sets the password. The DCE sends the numeric string contained in +FPW atthe times specified in T.30, if the corresponding parameter is not zero string. valid values: 0-9, *, #, space.13.36 Receive quality thresholds +FRQCommand syntaxDescriptionAT+FRQ=, This command allows to make the “Copy Quality OK” decision using the commandparameter. The command has no effect. in range 0-64H. in range 0-FFH.13.37 Error correction mode retry count +FRYCommand syntaxDescriptionAT+FRY= This command has no effect.59