Heavy Duty Encoder - Hengstler Encoders

ACCESSORIESRIM SSWNorthStar brandRIM SSW Signal SwitcherKey Features• Eliminates Need for Two PLCs or InputDevices• Accepts A, B, and Z Inputs from TwoSeparate Encoders• May Switch Two Encoders of DifferentResolutions for Coarse and Fine PositionControl• Can Select Spare Encoder that Acts asBackup of First• Input Voltage Range from 4 to 26 VDCSPECIFICATIONSSTANDARD OPERATING CHARACTERISTICSInput Signal: 2 or 3 channel quadrature signal,sine or square wave, open collector, differential, orsingle ended line driverELECTRICALInput Signal Voltage: 4 - 26 VDCInput Signal Current: 2.2 mA minimum, 3.5 mAtypicalInput Signal Impedance: Optically isolated, 1 kOhm at 4V, 6.8 k Ohms at 24V typical. Currentlimited.Operating Frequency Range: 0 - 100 kHzOutput Signal: Differential driven square wave,signal level approximately equivalent to inputsupply voltage.Error Output Signal: Sinking normally open,closes on error. 5V, 20 mA maximum loadSupply Voltage: 5 - 26 VDCCurrent Consumption: Less than 150 mA at 100kHz and 26 VDC typical with no output driver loadOutput Current: 150 mA (maximum)Power Up Time: Less than 10 msEncoder Switching Time: Less than 8 µsConnector Wire Gauge: 26 -16 AWGElectrical Protection: Reverse polarity protectedOutput Protection: Under voltage, short circuit,and thermally protectedFail Safe Feature: Fail safe mode connectsdevice’s ENCODER 1 INPUT directly to device’sOUTPUT terminalsMECHANICALEnclosure Material: PVCSide Element Material: Polyamide PA nonreinforcedMounting Options: DIN 35 or 32DIMENSIONS inches [mm]ENVIRONMENTALOperating Temperature: 0°C to 50°CStorage Temperature: -20°C to 70°COperational Humidity: 98% non-condensing*Specifications subject to change without noticeORDERING INFORMATIONPart Number: RIMSSW5.16