NanoLC 1D Plus and 2D System Operator's Manual - Eksigent

Chapter 2.System InstallationChapter 2 describes the recommended procedure for unpacking and installing the nanoLC system.Topics covered in this chapter include:• nanoLC system overview (Section 2.1)• unpacking the nanoLC system (Section 2.2)• placement of the system (Section 2.3)• connecting to the air supply (Section 2.4)• connecting the PC (Section 2.5)• installing the nanoLC Autosampler (Section 2.6)• connecting the nanoLC to power (Section 2.7)• installing software and instrument settings (Section 2.8)• configuring the nanoLC system (Section 2.9)• configuring the nanoLC Autosampler (Section 2.10)2.1 nanoLC System OverviewThe nanoLC systems are designed for HPLC applications that employ direct pumping at flow rates ofseveral hundred nL/min. The fully integrated system includes binary gradient pumps, an additional pumpor second binary gradient pump system, temperature-controlled flow modules, and a column switchingvalve. The system is compatible with the nano LC Autosampler. This chapter introduces the hardwareand software features of the nanoLC systems.2.2 Unpacking the nanoLC Systemstep 1step 2step 3step 4Inspect the shipping cartons for damage or evidence of mishandling. If external damage is evident,notify the carrier before opening the cartons.Cut the tape and open the flaps on the top of the nanoLC system shipping box. Remove the outershipping box.Open the inner shipping box and remove the foam packing material from the top of the nanoLCsystem.Carefully lift the nanoLC system out of the box. Grasp the sides of the instrument; do not use theprotective bag to lift the instrument. A second person may be needed to help slide the carton andfoam inserts off the instrument.nanoLC Operator’s Manual 611-00012 Revision A1