Untitled - Flannery Plant Hire

OPERATOR'S STATIONStation Presetting Procedure1. Select the desired station using tuning switches (5).(Refer to the “Tuning Procedure” section.)2. Press and hold one station preset (4) for more than 1second until an electronic tone is heard. Now, the selectedstation is preset for the selected station preset.The frequency of the preset station will be indicatedon digital display (7).47Once the presetting is complete for a station preset (4),the radio will be tuned to the preset station when stationpreset (4) is pressed (for less than 1 second).5M1G6-01-026DIGITAL CLOCK SETTING PROCEDURE7NOTE: In order to set the clock, digital display (7) mustbe in the time display mode.1. Press display mode button (6) to indicate the hourdisplay on digital display (7).2. Press and hold time set button (RST) (8) for longerthan 1 second. The hour display will start flashing andthe time set mode will be selected.3. Press time set button (H or M) (8) to set the clock.Each time time set button (H or M) (8) is pressed, thetime display will increase by one. If time set button (Hor M) (8) is pressed and held, the time display willchange continuously.• When setting the hour, pres time set button (H) (8).• When setting the minute, press time set button (M)(8).The time is displayed in 12 hour standard.If either of the switches (H) or (M) is pressed andheld, the hour or minute display will change continuouslyuntil the switch is released.4. When the hour display is “12,” if time set button (H)(8) is pressed, the hour display will be reset to “1.”When the minute display is “59,” if time set button(M)(8) is pressed, the minute display will be reset to“00.” However, the hour display remains unchangedin this case.5. After the clock setting is complete, press and holdtime set button (RST)(8) again for longer than 1 second,or turn the radio switch OFF to end the clocktime setting procedure. Digital display (7) stopsflashing and changes to stay ON.68M1G6-01-0261-53