Untitled - Flannery Plant Hire

OPERATOR'S STATIONADJUSTING THE SEATSeat Height and Angle AdjustmentSeat height adjustment range is 60 mm (2.4 in) withsteps every 15 mm (0.6 in) (5 positions in total). Moreover,the height of the front part and the rear part of theseat are adjusted independently, thus allowing the angleof the seat to be adjusted.CAUTION: Avoid possible injury while operatinglever (1). When pushing down lever (1), do notgrab it. Fingers may be pinched between lever (1)and the seat stand. Be sure to push on the upperface of lever (1).Use lever (1) to adjust the seat height and/or seat angleas follows:• To adjust the front part of the seat:Push down lever (1) while sitting on the seat, and applyor remove body weight to obtain the desired height.When the desired height is obtained, release lever (1).• To adjust the rear part of the seat:Pull up lever (1) while sitting on the seat, and apply orremove body weight to obtain the desired height.When the desired height is obtained, release lever (1).Caution: Possibility ofpinched fingersPush down with thepalm.SS-74751Console and Seat Fore-aft AdjustmentPull lever (2) to the right to adjust the seat and both rightand left consoles to desired distance from the travelpedals and levers. Release lever to lock seat and consolesinto position.NOTE: Seat and console fore-aft adjustment range is120 mm (4.7 in) with steps every 20 mm (0.8in).243M178-02-066Seat Fore-Aft AdjustmentPull lever (3) to the right to unlock the seat from bothconsoles. With lever held to the right, slide the seat tothe desired distance from pilot control levers. Releasethe lever.NOTE: Seat fore-aft adjustment range is 160 mm (6.3in) with steps every 16 mm (0.8 in).Suspension AdjustmentTurn knob (4) clockwise to increase suspension stiffness.Turn knob counterclockwise to decrease suspensionstiffness.Backrest AdjustmentPull up lever (5) to release backrest lock. Move backrestto the desired position and release the lever.1-59