Untitled - Flannery Plant Hire

MAINTENANCEReplace Air Breather Element--- every 4000 hoursCAUTION: Hydraulic oil may be hot just afteroperation. Hot hydraulic oil may spout, possiblycausing severe burns. Be sure to wait for oil tocool before starting work.Replacement Procedures1. Park the machine on solid and level ground. Fullyextend the bucket cylinder, fully retract the arm cylinder,and lower the bucket to the ground as illustratedto the right. Stop the engine.2. Before replacing the element, be sure to bleed airpressure from the hydraulic oil tank by pressing theair bleed valve on the hydraulic oil tank.3. Turn cover (2) clockwise about 1/4 turn. Turn cap (1)counterclockwise to remove it.4. Turn cover (2) counterclockwise to remove it. Then,remove element (3).5. Install new element (3). Tighten to install cover (2)until cover (2) comes in contact with the element.Then, further tighten the cover 1/4 turn.6. Securely tighten cap (1) clockwise by hand. Whileholding cap (1) by hand so that cap (1) doesn’t rotate,securely tighten cover (2) by rotating counterclockwise5 to 10! by hand.7. Take care never to allow water and/or contaminant tostay between cover (2) and body (4) (air breathingport).8. Replace the element periodically to keep hydraulic oilclean and to extend hydraulic components servicelife.1234M202-07-028M157-07-185M1G6-07-0017-49