36e Operator's Manual 2013.pdf - Marlow-Hunter, LLC

Hunter e36 • DC Electrictery switch panel supplies power to the optional windlasson your boat. The windlass (shown in Fig. 7.5) offers youthe ability to raise and lower your anchor.7.3.11.1 To operate the windlass:Lower Anchor1. Turn on battery switch.2. Turn on windlass breaker at DC Panel.3. Push windlass “Down” button on nav station.Note: “Bump” switch until anchor clears anchor roller andhull before letting anchor down freely.Raising Anchor1. Start boat engine, this will allow control of boat whenanchor becomes free, as well as reducing load on battery.2. Push windlass “Up” button being careful as the anchorapproaches the hull and anchor roller. Continue until theanchor rests in the stemhead properly.Note: If it appears there is no power to the windlass,check reset breaker in stbd. aft cockpit locker. If windlassbecomes inoperable electrically, a manual winch handleis supplied.7.3.12 InstrumentsThe breaker marked “Instruments”, on the 12 Volt DCPanel supplies power to the instruments on your boat.For more information about the controls of your instrumentsconsult product manual in your owner’s packet.7.3.13 GPS (optional)The breaker marked “GPS”, on the 12 Volt DC Panelsupplies power to the chart plotter on your boat. Formore information about the controls of your instrumentsconsult product manual in your owner’s packet.7.3.14 TV/DVD (optional)The reset marked “TV/DVD”, on the 12 Volt DC Panelsupplies power to the TV/DVD on your boat. For moreinformation about the controls of your instruments consultproduct manual in your owner’s packet.7.3.15 Head (optional)The breaker marked “Head”, on the 12 Volt DC Panelsupplies power to the Head on your boat. For moreinformation about the controls of your instruments consultproduct manual in your owner’s packet.For more information about your windlass, refer to yourowner’s manual.Anchor tie off cleatWindlassFigure 7.57.8