36e Operator's Manual 2013.pdf - Marlow-Hunter, LLC

Hunter e36 • DC Electric7.2.3 Battery Charging SystemRefer to the DC Wiring Diagram drawing at the end ofthis section for the location of the battery charger. Thecharger is protected by a fuse on the positive and groundside at the charger.To operate the charger, ensure that it is operating:1. Connect the shore power dockside supply shorepower inlet on the stern of the boat on the port side.2. Turn on AC Main breaker.3. Turn on the Battery Charger breaker.7.2.4 12 Volt DC PanelAll electrical systems aboard your boat are provided withover-current protection in the form of breakers or fuses.Examples of breakers are the system or component controlsat the 12 Volt Panel, or in the battery selector switchpanel. Systems that would normally require you to energizethem for use are provided with switches.7.2.6 Inverter (Option)Inverter converts DC power to AC.7.2.6.1 Inverter Basic Operation1. Turn the house battery switch to either the “1, 2 orBoth” positions2. Turn on inverter remote panel at the NavigationStation.OFF12V DCRUNNING LIGHTSANCHOR LT3. Turn on the appropriate appliance breaker on ACPanel. Note: only Outlets and microwave operating usingthe inverter.STEAMING LTOFFOFFWATER PUMPBLOWERVOLTSSee Inverter manual for technical data, troubleshooting,etc. operatiing/programming instructions.OFFOFFMACERATORGPSPANELLTS7.2.7 Generator (Option)OFFCABIN LIGHTSINSTRUMENTSTV/DVDBILGEPUMPAlthough, technically, the generator is part of the ACSystem, because it supplies AC power, however the startingof the generator requires DC power. The generatorstarting receives power from the start battery bank.LPGSTEREOREFRIGERATORSUMP PUMPHEAD12V OUTLETSTANK INDICATORSPAREThe generator supplies 120 volt 60 hz AC power foroperating devices and equipment controlled through theAC Control Panel.Figure 7.2You can view the DC components controlled by the DCcontrol panel here (Fig. 7.2). Notice when the batteryselector switch is switched on the respective voltage ofthe battery is shown on the right by the digital volt meter.Indicator lights are built into most switches and alert youthat the selected system is powered.7.2.5 Breakers, Switches, and FusesWhen the generator indicating light is on and the generatorbreakers are on, AC power is supplied to AC controlpanel devices and equipment.Refer to the “Operation and Procedures” part of the ACElectric section for information on starting the generator.You can find the location of the generator on the DCWiring Diagram drawing at the end of this chapter.7.2.8 Water SystemsThe water systems are outlined in the Water Systemschapter in this manual. However, the monitor for this systemare powered by the DC Electrical system.7.4