36e Operator's Manual 2013.pdf - Marlow-Hunter, LLC

Hunter e36 • Maintenancethese compartments out then use a sponge to remove allremaining water.Procedures for draining and winterizing the fresh watersystem are in this section under the “Preparing forStorage” heading.14.6.2 Preparing for Storage* Clean, scrub, and sponge the hull and deck as soon asthe boat is pulled from the water and is still in the sling.Cleaning marine growth from the hull is easier when it isstill wet.* Clean the inside of all hull openings, through hull fittings,and screens. Inspect the hull and underwater gearfor signs of wear, deterioration, or damage. Note anydamage to the propulsion equipment, helm area, cabin,etc. Make repairs, if at all possible, before covering yourboat.* Fill the fuel tanks with treated fuel to prevent condensation.If you use a stabilizer or conditioner, be sure tofollow the instructions on the container.Important: Do not overfill fuel tanks so fuel flows from the vent.Allow room in the tanks for fuel to expand.** Prepare the Engines for Storage:* In areas where temperatures fall below freezing, thebilge area under the engines must be pumped out andsponged completely dry. Check for areas that do notdrain to the pumps. Drain mufflers.* Close head intake seacock and remove hose.* Pour the nontoxic antifreeze into the head and keepflushing the head until the antifreeze reaches the holdingtank.* If your boat has a macerator discharge and the boatis removed from the water, run the macerator pump longenough for antifreeze to run through the pump and thelines.* Remove drain plug from seacock while valve is closed.Allow line to drain. Replace drain plug.** Prepare the Fresh Water System:* Remove the fresh water supply by opening the hot andcold faucets in the galley for 10 minute intervals. Repeatuntil the fresh water tank is empty.* Open all faucets: galley, shower, cockpit shower, etc.* Drain the water heater. Disconnect lines from theengine heat exchanger (if equipped). Drain exchangerand lines.* Remove hot and cold water lines and hook themtogether.* Remove inlet hose from tank and insert it into a containerof nontoxic antifreeze. Turn pump on. Startingat faucet furthest from pump, open all faucets until antifreezeflows out.Note: Refer to the engine owner’s manual for winterization andstorage procedures.** Prepare the Batteries for Storage:* Be sure main battery breakers are off.* Remove batteries from boat and store in area wheretemperatures remain above freezing.* Place batteries on a wooden pallet or bench.* Keep batteries charged. Check electrolyte levels regularly.Add electrolyte if needed.** Prepare Holding Tank* Empty and rinse holding tank until tank is clean.14.9* Turn off pump and reconnect hose to water heater andpump.* Remove seacock drain plugs to prevent damage fromfreezing. Close all seacocks.** Prepare Interior of Boat for Storage:* To keep mildew from forming, remove all items that willhold moisture ( PFD’s, towels, blankets, clothing, canvas,etc.).* Make sure all garbage is removed.* Scrub the inside of the boat. Clean cabinets, drawers,and cupboards. Allow cabin area to dry and air for atleast one day if possible.* Stand or prop up mattresses and cushions remaining