Artis zee/zeego VC14 - Siemens Healthcare

sArtis zee/zeego VC14DICOM Conformance StatementPrinter Status Info/Message string visible Other action for UI/DescriptionExecution Status Infoin ‘Status Bar’’camera symbol’LOW A4 PAPR The A4 paper supply magazine is low. A4 paper supply low. /interactLOW A4 TRANSThe A4 transparency supply magazine A4 transparency supplyis low..low./interactNO RECEIVE MGZThe film receive magazine is not Film receiver notavailable.available./interactNO RIBBONThe ribbon cartridge needs to bereplaced.Replace ribbon cartridge. /interactNO SUPPLY MGZThe film supply magazine is notavailable.Film supply not available. /interactCHECK PRINTERThe printer is not ready at this time,operator intervention is required to Check camera./interactmake the printer available.CHECK PROCThe processor is not ready at this time,operator intervention is required to Check processor./interactmake the printer available.PRINTER DOWNThe printer is not operating due tosome unspecified reason.Camera down./interactPRINTER INITThe printer is not ready at this time, it isexpected to become available withoutintervention. For example, it may be inCamera initializing./Idlea normal warm-up state.PRINTER OFFLINEThe printer has been disabled by anoperator or service person.Camera off-line./interactPROC DOWNThe processor is not operating due tosome unspecified reason.Processor down./interactPROC INITThe processor is not ready at this time,it is expected to become availablewithout intervention. For example, itProcessor initializing./Idlemay be in a normal warm-up state.PROC OVERFLOW FLProcessor chemicals are approaching Processor chemicalsthe overflow full mark.near overflow./interactPROC OVERFLOW HIProcessor chemicals have reached the Processor chemicalsoverflow full mark.overflow./interactQUEUED Print job in Queue -- /IdleRECEIVER FULL The film receive magazine is full. Receiver full. /interactREQ MED NOT INSTThe requested film, paper, or othermedia supply magazine is installed inthe printer, but may be available withoperator intervention.Install media supply. /interactREQ MED NOT AVAIThe requested film, paper, orother media requested is notavailable on this printer.Media supply notavailable on this camera.Queue stopped. Changecamera.Queue for thiscamera will beSTOPPED/Queue stoppedRIBBON ERRORThere is an unspecified problem withthe print ribbon.Error with print ribbon. /interactSUPPLY EMPTY The printer is out of film. Camera out of film. /interactSUPPLY LOW The film supply is low. Film supply low. /interactUNKNOWNThere is an unspecified problem.Unspecified problem withcamera./interact8.9.2 Additional Status Information - AGFA printersPrinter Status Info/Execution Status InfoWARMING UPOFFLINENONETable 84 - Print SCU additional AGFA Printer Status evaluationDescriptionPrinter is in the warm-up stage.Spooling of print jobs to disk is stillpossible.OFFLINE Printer is switched off-line.Spooling of print jobs to disk is stillpossible.General printer warning, no specificinformation is available. Spooling ofprint jobs to disk is still possible.Message string visiblein ‘Status Bar’Camera is warming up.Camera is switched offline.Other action for UI/’camera symbol’/idle/interact-- /idle© Siemens AG, Healthcare Sector 2009 Rev. 08 Page 100 of 105