FR-A701 INSTRUCTION MANUAL (Applied) - Automation Systems ...

4PARAMETERSFrequency setting by external terminals(2) Jog operation from PU⋅ Set the PU (FR-DU07/FR-PU07/FR-PU04) to thejog operation mode. Operation is performed onlywhile the start button is pressed.Three-phase ACpower supplyInverterR/L1S/L2T/L3UVWMotorFR-DU071.2.OperationConfirmation of the RUN indication andoperation mode indicationThe monitor mode should have been selected.The inverter should be at a stop.Press to choose thePU JOG operation mode.Indication3. Press (or ).5.6.7.While (or ) is pressed, themotor rotates.Rotates at 5Hz. (initial value of Pr. 15)4. Release (or ).[When changing the frequency of PU JOGoperation]Press to choose the parametersetting mode.Turn until Pr. 15 JOG frequencyappears.Press to show the currently setvalue. (5Hz)Hold down.ReleaseStopThe parameternumber readpreviouslyappears.8.9.10.Turn to set the value to" ". (10Hz)Press to set.Perform the operations in steps 1 to 4.The motor rotates at 10Hz.Flicker Parameter setting complete!!CAUTION⋅ When Pr. 29 Acceleration/deceleration pattern selection= "1" (S-pattern acceleration/deceleration A), the acceleration/decelerationtime is the period of time required to reach Pr. 3 Base frequency.⋅ The Pr. 15 setting should be equal to or higher than the Pr. 13 Starting frequency setting.⋅ The JOG signal can be assigned to the input terminal using any of Pr. 178 to Pr. 189 (input terminal function selection). When terminalassignment is changed, the other functions may be affected. Please make setting after confirming the function of each terminal.⋅ During jog operation, the second acceleration/deceleration via the RT signal cannot be selected. (The other second functionsare valid. (Refer to page 210))⋅ When Pr. 79 Operation mode selection = "4", push / of the PU (FR-DU07/FR-PU04/FR-PU07) to make a start or pushto make a stop.⋅ This function is invalid when Pr. 79 = "3".⋅ Jog operation is invalid under position control.♦ Parameters referred to ♦⋅ Pr. 13 Starting frequency Refer to page 157⋅ Pr. 29 Acceleration/deceleration pattern selection Refer to page 158⋅ Pr. 20 Acceleration/deceleration reference frequency, Pr. 21 Acceleration/deceleration time increments Refer to page 155⋅ Pr. 79 Operation mode selection Refer to page 283⋅ Pr. 178 to Pr. 189 (input terminal function selection) Refer to page 206151