EMCO WinNC SINUMERIK 810/820 T Software Description ...

More documents

Recommendations

Info

EMCO WINNC SINUMERIK 810/820 TPROGRAMMINGG90 Absolute ProgrammingFormatN... G90The addresses have to be programmed as following:X ..........diameterZ+/-......absolute (referred to the workpiece zeropoint)Note• Direct switchover within a block between G90 andG91 is not possible.• G90 (G91) may also be programmed with someother G functions (N... G90 G00 X... Z...).G91 Incremental ProgrammingFormatN... G91The addresses have to be programmed as following:X ..........radiusZ ..........Incremental (real) traverse path with signNote see G90.G92 Spindle Speed LimitFormatN... G92 S...[U/min]With G92 a maximum spindle speed (rev/min) can bedetermined for a part program (effective only inconnection with G96).Enter the desired maximum speed with address S.This command is used in conjunction with constantcutting speed.D 14
EMCO WINNC SINUMERIK 810/820 TPROGRAMMINGG 92 Cylindrical interpolationFormatN... G92 P.. CG92 P.. ...... Cylindrical interpolation ONG92 P1 ...... Cylindrical interpolation OFFP ................. Factor for unit circleC................. Axis name for rotary axisCylindrical interpolation permits machining of cylindricalpaths with one rotary axis and one linear axis.Both linear and circular contours may be programmed.It is not possible to input the interpolation parametersI, J and K.The position of the rotary axis is entered in degrees.The ration is programmed under G92 P... for thispurpose.The control forms the ration from the machiningdiameter and the unit diameter as follows:P=machining diameterunit diameterThe unit diameter is derived from the ralationp x π = 360 abUnit diameter =360πin mm or inchNo characters other than axis name must be writtenin a block containing G92P...D 15
Page 2 and 3: EMCO WINNC SINUMERIK 810/820 TPREFA
Page 4 and 5: EMCO WINNC SINUMERIK 810/820 TCONTE
Page 6 and 7: EMCO WINNC SINUMERIK 810/820 TKEY D
Page 13 and 14: EMCO WINNC SINUMERIK 810/820 TBASIC
Page 21 and 22: EMCO WINNC SINUMERIK 810/820 TOPERA
Page 33 and 34: EMCO WINNC SINUMERIK 810/820 TPROGR
Page 45: EMCO WINNC SINUMERIK 810/820 TPROGR
Page 65 and 66: EMCO WINNC SINUMERIK 810/820 T@-COD
Page 67 and 68: EMCO WINNC SINUMERIK 810/820 T@-COD
Page 69 and 70: EMCO WINNC SINUMERIK 810/820 TSURVE
Page 77 and 78: EMCO WINNC SINUMERIK 810/820 TALARM

EMCO WinNC SINUMERIK 810/820 T Software Description ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?