EMCO WinNC SINUMERIK 810/820 T Software Description ...

EMCO WINNC SINUMERIK 810/820 TSURVEY PAGESG: Survey PagesSurvey Softkey ExplanationsACTUAL BLOCK(Current block)The current block is the block currently beingprocessed. The display shows: The block before thecurrent block, the current block and the block afterthe current block.ADD. FUNCTION(Additional function)The additional functions (5th M Group) fixed by themachine tool manufacturer are grouped together inthis function. Preselect: softkey „GUIDING“AREA W-PIECE(Work piece area)You enter the simulation area, and the workpiecedimensions.AXIALYou enter the setting data for the axes.BLOCK ENDYou select the character for „Block End (LF)“ viasoftkey.Preselect: „GUIDING“ softkey.BLOCK NUMBERThe block number is automatically generated by thecontrol in steps of five.BLOCK SEARCHBlock search makes it possible to start the operationat any point in the program. During block search, thesame calculations are carried out as in normal programoperation, however there is no axis movement.BTR STARTnot activeCIRCLEYou select the G functions for circular interpolationwith this softkey.Preselect: „GUIDING“ softkey (operator prompting).CONTOURThis function simplifies programming of workpiececontours with the transfer of values directly from thedrawing and graphic displays.You can select the following elements and combinations:• Line• Line - circle• Circle• Circle - line• Circle - circle• 2 - point definition• 2 - angle definitionCOPYYou copy a part program and re-enter it into memoryunder another program number.CORR. BLOCK(Correction block)An error in the program is marked with the cursor(correction pointer).CURRENT PRG PTR(current program pointer)The display shows the subroutine nesting with numberof runs and actual block number of the subroutine.CURRENT VALUESThe display shows the values valid for the currentoperating sequence.CYCLESThe following are displayed:• The stored cycle numbers• The number of characters used• The free memory spaceCycles are protected subroutines which can be calledfor frequently used technologies or for machinespecificoperations (stock removal cycles, drillingcycles, tool change cycles).The values required are defined as parameter assignmentsbefore the cycles are called (cycle parameterassignment).G 1