EMCO WinNC SINUMERIK 810/820 T Software Description ...

EMCO WINNC SINUMERIK 810/820 TALARMS / MESSAGES2046 Block greater than 120 charactersCause:NC block is too long (with loading a program)Remedy: divide NC block in several blocks with DOSeditor2048 Nxxxx Circle end point errorCause: invalid circle, invalid circle centre, radiustoo smallRemedy: correct program2060 Nxxxx Pogramming error TO, ZOCause: D number too great, tool type not allowedRemedy: correct program2061 Nxxxx General program errorCause: NC block structure wrong, block number,M/H/G code not allowed, invalid combinationof G commands, radius/dwell programmedtwice, dwell time too long, circle alreadyprogrammed, general block structure errorwith calculating operationRemedy: correct program2062 Nxxxx Feed missing / not progr.Cause: F value too great, attempt to start with F=0,also with G95/96, if S=0 or M5Remedy: correct program2063 Nxxxx Thread lead to highCause: thread pitch too great / missing, feed withthreads reaches 80% of rapid speedRemedy: correct program, smaller pitch or lowerspeed with threads2065 Nxxxx Pos behind SW overtr. switchCause: target point programmed out of softwareend switch or circle path overtravelssoftware end switchRemedy: correct program2068 Nxxxx Pos behind working areaCause: target point programmed out of working areaRemedy: correct program2072 Nxxxx Incorrect input valueCause: chamfer/radius too largeRemedy: correct program2073 Nxxxx No intersection pointCause: no intersection point with contour definitionarc-lineRemedy: correct program2074 Nxxxx Wrong angle valueCause: no contour draft is possible with that angleRemedy: correct program2075 Nxxxx Incorrect radius valueCause: wrong circle centre point or radiusRemedy: correct program2076 Nxxxx Wrong G02/G03Cause: wrong rotational direction for tangentialdraft arc-line programmedRemedy: correct program2077 Nxxxx Incorrect block sequenceCause: chamfer/radius: no 2. traverse block wasprogrammedRemedy: correct program2081 Nxxxx CRC not allowedCause: thread, change of correction direction/mirroraxis/tool correction not allowed with CRC,circle not in selected CRC plane, change ofplane while CRCRemedy: correct program2082 Nxxxx CRC not determinableCause: plane change CRC not allowed, invalidcontour element, contour violation full circle,contour element too shortRemedy: correct program2160 Nxxxx Scale factor not allowed2171 Nxxxx Approach not possibleCause: no tool correction, tool radius = 0 (CRC)Remedy: select tool, enter tool radius in tool data2172 Nxxxx Retract not possibleCause: error with selection CRCRemedy: correct program2501 ORDxx Synchronisation-error ACRemedy: RESET, report to EMCO if repeatable2502 ORDxx Synchronisation-error ACRemedy: RESET, report to EMCO if repeatable2503 ORDxx Synchronisation-error ACRemedy: RESET, report to EMCO if repeatable2504 ORDxx Insuff. RAM for interpreterCause: not enough RAM memory, continuation ofthe program not possibleRemedy: close all other WINDOWS applications,cease program, remove resident programs(from AUTOEXEC.BAT and CON-FIG.SYS), restart PC2505 ORDxx Insuff. RAM for interpretersee 25042506 ORDxx Insufficient RAMsee 25042507 ORDxx Referencepoint not activeRemedy: approach reference point2508 ORDxx Intenal error NC coreRemedy: RESET, report to EMCO if repeatableH 3