EMCO WinNC SINUMERIK 810/820 T Software Description ...

More documents

Recommendations

Info

EMCO WINNC SINUMERIK 810/820 TPROGRAMMINGXExample Cylindrical interpolationø38,2 x π = 120360°YR2,5Z15YG54G58 Z40T7 D7F200 S2=2000 G94 M2=3M52 Couple in and Positioning of the spindleG92 P0.33 C Cylindrical interpolation ON.Unit diameter = 360/PI = 114.59P =38.2 /114.59= 0.33C = Axis name for round axisG0 X45 Z-5G1 X35 C0 Z-5G1 Z-15 C22.5Z-5 C45Z-15 C67.5Z-5 C90Z-15 C112.5Z-5 C135Z-15 C157.5Z-5 C180Z-15 C202.5Z-5 C225Z-15 C247.5Z-5 C270Z-15 C292.5Z-5 C315Z-15 C337.5Z-5 C360X45G92 P1Cylindrical interpolation OFFM53C- axis OFFG0 X80 Z100M2=5 Spindle for driven tool OFFM30ZMilled with end milling cutter ø5mmD 16
EMCO WINNC SINUMERIK 810/820 TPROGRAMMINGG94 Feed per MinuteBy G94 all F (feed) values are in mm/min (inch/min).G95 Feed per RevolutionBy G95 all F (feed) values are in mm/revolution (inch/revolution).G96 Constant Cutting SpeedUnit: m/min feet/minThe control computes the spindle speed for theactual diameter continuously.With diameters decreasing to 0 the speed shouldincrease to infinite.In fact it increases to the maximum speed of themachine and the program runs on without alarm.If the maximum speed is to high (e.g.: limited chuckspeed, unbalanced work pieces, ...) G92 has to beprogrammed additionally to delimit the speed.Feed is automatically set to G95 (mm/rev, inch/rev).No zero offset in X direction must be active.G97 Constant Spindle SpeedUnit: rev/minG96 will be deselected and the spindle speed will beholded at the last valid value. Afterwards S will beprogrammed in rev/min.D 17
Page 2 and 3: EMCO WINNC SINUMERIK 810/820 TPREFA
Page 4 and 5: EMCO WINNC SINUMERIK 810/820 TCONTE
Page 6 and 7: EMCO WINNC SINUMERIK 810/820 TKEY D
Page 13 and 14: EMCO WINNC SINUMERIK 810/820 TBASIC
Page 21 and 22: EMCO WINNC SINUMERIK 810/820 TOPERA
Page 33 and 34: EMCO WINNC SINUMERIK 810/820 TPROGR
Page 47: EMCO WINNC SINUMERIK 810/820 TPROGR
Page 65 and 66: EMCO WINNC SINUMERIK 810/820 T@-COD
Page 67 and 68: EMCO WINNC SINUMERIK 810/820 T@-COD
Page 69 and 70: EMCO WINNC SINUMERIK 810/820 TSURVE
Page 77 and 78: EMCO WINNC SINUMERIK 810/820 TALARM

EMCO WinNC SINUMERIK 810/820 T Software Description ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?