EMCO WinNC SINUMERIK 810/820 T Software Description ...

EMCO WINNC SINUMERIK 810/820 TALARMS / MESSAGES6019: VICE TIMEOUT24 V fuse defective, hardware defective.Contact EMCO service.6020: VICE FAILURE24 V fuse defective, hardware defective.Contact EMCO service.6024: DOOR NOT CLOSEDThe door was opened while a machine movement.The program will be aborted.6025: GEARBOX COVER NOT CLOSEDThe gearbox cover was opened while a machinemovement. A running CNC program will be aborted.Close the cover to continue.6027: DOOR LIMIT SWITCH DEFECTIVEThe limit switch of the automatic door is displaced,defective, wrong cabled.Contact EMCO service.6028: DOOR TIMEOUTThe automatic door stucks, the pressured air supplyis insufficient, the limit switch is displaced.Check door, pressured air supply, limit switch orcontact EMCO service.6030: NO PART CLAMPEDNo workpiece inserted, vice cheek displaced, controlcam displaced, hardware defective.Adjust or contact EMCO service.6041: TOOL CHANGE TIMEOUTTool turret stucks (collision?), 24 V fuse defective,hardware defective.A running CNC program will be stopped.Check for a collision or contact EMCO service.6042: TOOL CHANGE TIMEOUTsee 6041.6043: TOOL CHANGE TIMEOUTsee 6041.6044: TOOL TURRET SYNC ERRORHardware defective.Contact EMCO service.6048: DIVIDING TIME EXCEEDEDDividing head stucks, insufficient pressured air supply,hardware defective.Check for collision, check pressured air supply orcontact EMCO service.6049: INTERLOCKING TIME EXCEEDEDsee 60486050: FAILURE DIVIDING DEVICEHardware defective.Contact EMCO service.7000: INVALID TOOL NUMBERThe CNC program will be stopped.Interrupt program with RESET and correct the program.7007: FEED HOLDIn the robotic mode a HIGH signal is at input E3.7.Feed Stop is active until a low signal is at E3.7.7017: GO FOR REFERENCE POINTApproach the reference point.7040: DOOR OPENThe main drive can not be switched on and NC-Startcan not be activated.Some accessories can be operated only with openmachine door.Close the machine to run a program.7043: PIECE COUNT REACHEDA predetermined number of program runs wasreached. NC-Start is locked. Reset the counter tocontinue.7050: NO PART CLAMPEDAfter switching on or after an alarm the vice is neitherat the open position nor at the closed position.NC-Start is locked.Traverse the vice manually on a valid end position.7051: DIVIDING DEVICE NOT INTERLOCKEDAfter switching on or after an alarm the dividing headis not in a lock position. NC-Start is locked.6046: TOOL TURRET SYNC MISSINGHardware defective.Contact EMCO service.H 10