EMCO WinNC SINUMERIK 810/820 T Software Description ...
EMCO WinNC SINUMERIK 810/820 T Software Description ...
EMCO WinNC SINUMERIK 810/820 T Software Description ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>EMCO</strong> WINNC <strong>SINUMERIK</strong> <strong>810</strong>/<strong>820</strong> TPROGRAMMINGG94 Feed per MinuteBy G94 all F (feed) values are in mm/min (inch/min).G95 Feed per RevolutionBy G95 all F (feed) values are in mm/revolution (inch/revolution).G96 Constant Cutting SpeedUnit: m/min feet/minThe control computes the spindle speed for theactual diameter continuously.With diameters decreasing to 0 the speed shouldincrease to infinite.In fact it increases to the maximum speed of themachine and the program runs on without alarm.If the maximum speed is to high (e.g.: limited chuckspeed, unbalanced work pieces, ...) G92 has to beprogrammed additionally to delimit the speed.Feed is automatically set to G95 (mm/rev, inch/rev).No zero offset in X direction must be active.G97 Constant Spindle SpeedUnit: rev/minG96 will be deselected and the spindle speed will beholded at the last valid value. Afterwards S will beprogrammed in rev/min.D 17
Change language