SIM300D AT Command Set - Distributed Systems and Networking
SIM300D AT Command Set - Distributed Systems and Networking
SIM300D AT Command Set - Distributed Systems and Networking
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SIM300D</strong> <strong>AT</strong> <strong>Comm<strong>and</strong></strong> <strong>Set</strong><br />
Confidential SIMCOM<br />
default is <strong>AT</strong>+COLP=0, this cause the TA returns “OK” immediately<br />
after dialing was completed, otherwise TA will returns “OK”,<br />
“BUSY”, “NO DIAL TONE”, “NO CARRIER”.<br />
Using <strong>AT</strong>D during an active voice call:<br />
� When a user originates a second voice call while there is already an<br />
active voice call, the first call will be automatically put on hold.<br />
� The current states of all calls can be easily checked at any time by<br />
using the <strong>AT</strong>+CLCC comm<strong>and</strong>.<br />
2.2.4 <strong>AT</strong>D> Originate call to phone number in memory <br />
<strong>AT</strong>D> Originate call to phone number in memory <br />
Execution comm<strong>and</strong><br />
<strong>AT</strong>D>[][][;]<br />
Response<br />
This comm<strong>and</strong> can be used to dial a phone number from a specific<br />
phonebook.<br />
Note: This comm<strong>and</strong> may be aborted generally by receiving an <strong>AT</strong>H<br />
comm<strong>and</strong> or a character during execution. The aborting is not possible<br />
during some states of connection establishment such as h<strong>and</strong>shaking.<br />
If error is related to ME functionality<br />
+CME ERROR: <br />
If no dial tone <strong>and</strong> (parameter setting <strong>AT</strong>X2 or <strong>AT</strong>X4)<br />
NO DIALTONE<br />
If busy <strong>and</strong> (parameter setting <strong>AT</strong>X3 or <strong>AT</strong>X4)<br />
BUSY<br />
If a connection cannot be established<br />
NO CARRIER<br />
If connection successful <strong>and</strong> non-voice call.<br />
CONNECT TA switches to data mode.<br />
Note: output only if <strong>AT</strong>X parameter setting with the<br />
>0<br />
When TA returns to comm<strong>and</strong> mode after call release<br />
OK<br />
If successfully connected <strong>and</strong> voice call<br />
OK<br />
<strong>SIM300D</strong>_<strong>AT</strong>_V1.00 Page 12 of 180