SIM300D AT Command Set - Distributed Systems and Networking
SIM300D AT Command Set - Distributed Systems and Networking
SIM300D AT Command Set - Distributed Systems and Networking
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SIM300D</strong> <strong>AT</strong> <strong>Comm<strong>and</strong></strong> <strong>Set</strong><br />
Confidential SIMCOM<br />
Read comm<strong>and</strong><br />
<strong>AT</strong>+IFC?<br />
<strong>Set</strong> comm<strong>and</strong><br />
<strong>AT</strong>+IFC=[[,]]<br />
Reference<br />
V.25ter<br />
Parameter<br />
See set comm<strong>and</strong>.<br />
Response<br />
+IFC: ,<br />
OK<br />
Parameter<br />
See set comm<strong>and</strong>.<br />
Response<br />
This parameter setting determines the data flow control on the serial<br />
interface for data mode.<br />
OK<br />
Parameter<br />
specifies the method will be used by TE at receive of data<br />
from TA<br />
0 None<br />
<strong>SIM300D</strong>_<strong>AT</strong>_V1.00 Page 31 of 180<br />
1 XON/XOFF, don’t pass characters on to data stack<br />
2 line 133: Ready for Receiving<br />
3 XON/XOFF, pass characters on to data stack<br />
specifies the method will be used by TA at receive of data<br />
Note<br />
from TE<br />
0 None<br />
1 XON/XOFF<br />
2 line 106: Clear to send(CTS)<br />
� This flow control is applied for data mode;<br />
� SIMCOM use the RTS for this method.<br />
2.2.44 <strong>AT</strong>+ILRR <strong>Set</strong> TE-TA local rate reporting mode<br />
<strong>AT</strong>+ILRR <strong>Set</strong> TE-TA local rate reporting mode<br />
Test comm<strong>and</strong><br />
<strong>AT</strong>+ILRR=?<br />
Read comm<strong>and</strong><br />
<strong>AT</strong>+ILRR?<br />
Response<br />
+ILRR:(list of supported s<br />
OK<br />
Parameter<br />
See set comm<strong>and</strong>.<br />
Response<br />
+ILRR: <br />
OK<br />
Parameter<br />
See set comm<strong>and</strong>.
Change language