SIM300D AT Command Set - Distributed Systems and Networking

SIM300D AT Command Set
Confidential SIMCOM
6.4.2.11 Open Channel
Command response for Open Channel proactive command
Write Command
+STCR=40,
Reference Note
Parameters
40 hex notation: Command Type value.
See Section 6.2 for values.
integer: possible values:
0 Channel not accepted
1 Channel required.
6.4.2.12 Set Up Event List
Command response for Set Up Event List proactive command
Write Command
+STCR=05,
Reference Note
Parameters
05 hex notation: Command Type value.
See Section 6.2 for values.
integer: possible values:
0 Command performed successfully
1 Cannot perform command.
6.4.3 AT+STPD SIM Toolkit Profile Download
When an application is plugged into the serial port the command interpreter needs to have
knowledge of its SAT capabilities to enable it to route all SAT related signaling to that application
if required. If this command is not received it will be assumed that any attached application has no
SAT capability and will therefore not send any related signals to it. If the SIM has reported that it
does not have any proactive capability then an STC: 0 unsolicited response will be sent to the
application.
AT+STPD SIM Toolkit Command Response data
Write Command
+STPD=,
Response
OK
+CME ERROR:
+STC: 0
Parameter
Reference Note
Integer
SIM300D_AT_V1.00 Page 130 of 180
Determines the number of bytes of used for the Profile
Download data from the application.
List Of Hex Values, two digits each:
Hexadecimal representation of the Terminal Profile data
Some octets are optional in the profile, hence the inclusion of a length