MOPEX User's Guide - IRSA

6.6.1 APEX QA Modules: Initial Setup
Command Line Equivalent: N/A
Default Output Directory: N/A
De pe nds On: None
Relevant Pipelines: All
PURPOSE
INPUT
Set up the input and output files for the loaded flow.
MOPEX User’s Guide
Image Stack File: (Multiframe only) The text file containing the list of data files that you
used as input into the APEX Multiframe pipeline. See Chapter 3 and Table 3.1 for more
information on the input file requirements and format.
Mosaic File Name: (Single Frame only) The name of the single image that you used as input
into the APEX Single Frame pipeline.
FIF File: (Single Frame only) The name of the FIF.tbl file that describes the input mosaic.
This was either produced by the Mosaic pipeline and can be found in the output directory of
the Mosaic run.
Output Directory: The directory that you want to set as your output directory for this run.
Multi-processing Mode: Switch to use multi-processing. See Discussion.
Processors for Multi-processing: Number of processors to use. See Discussion.
Optional Input and Mask Files: (Multiframe Pipelines only)
Sigma List File: The text file containing the list of uncertainty images that correspond to
the files listed in Image Stack File (usually the *bunc.fits files; see Table 3.1 for more
information).
DCE Status Mask List: The text file containing the list of mask images that flag
temporarily-bad pixels in the files listed in Image Stack File. There should be a mask file
for each of the input data files (these depend on the instrument, but will be labeled
something like *msk.fits; see Table 3.1 for more information).
Point Source Extraction (APEX) 156
APEX QA Modules