Matest catalogue 2018

SECTION C | CONCRETE
313
ACCESSORIES TO COMPRESSION AND FLEXURAL TESTING MACHINES
C097-01
DUAL LOW CAPACITY DIGITAL RANGE
(From 1/3 to 1/20 of the nominal range), complete with Appropriate
pressure transducer, hydraulic installation and cock, fitted on
testing machines equipped with digital display measuring unit.
This solution offers very high accuracy also for measurements of
low strength, which is necessary to perform compression tests on
mortar specimens, flexural tests on concrete beams, split cylinder
test on cylinder and cube specimens, tests on kerbs, slabs etc., by
utilizing a concrete compression machine.
C097-05
CLASS 1 STARTING FROM 1% OF THE FULL RANGE
Applicable only to digital machines. By following a special calibration
procedure, Matest is capable to grant the Class 1 practically on
the full range, upgrading the machine to be used for a considerable
number of applications where low strength value are expected,
including:
- Lightweight concrete, or early strength concrete
- Small size samples, soil cement mixtures
- Flexural and tensile tests, slabs, kerbs, etc.
C097-08
OFFICIAL ACCREDIA HARDNESS CERTIFICATE
(Equivalent UKAS, ENAC, DAKKS, SAS, COFRAC etc.) of upper and
lower compression platens. Minimum hardness: 55 HRC.
C097-01
C097-02
DUAL LOW CAPACITY DIGITAL RANGE 0-300 KN
Complete with strain gage load cell, cables, fitted on concrete
compression testing machines equipped with digital display measuring
system.
This solution eliminates the weights of the piston and lower
compression platen, paking set frictions etc., granting very high
accuracy (Class 1; max. error within ± 0.5%) in the measuring
range 30...300 kN.
C097-08
H009-01
PERSONAL COMPUTER
Complete with LCD monitor, keyboard, mouse, connection cables,
it is applicable with all the Matest testing machines equipped with
digital display measuring system. The PC supply includes the installation
and the setting up of the purchased Software (see p. 18)
C097-02
C105
DEVICE WITH CENTRAL
SCREW
Very practical to adjust the light
between the compression platens
of a machine, according to
the height of the specimen to be
tested. Recommended solution
for machines equipped with big
sized platens. This device can be
foreseen on all models of concrete
compression machines,
except High Stability models.
C105
H009-01
C128
BENCH LASER PRINTER
For the graphic and test certificate
printing, applicable on all Matest
testing machines with digital
display measuring system.
The connection is direct by parallel
interface also without PC.
C128