Matest catalogue 2018

SECTION C | CONCRETE
375
C411N
PROFOMETER CORROSION
STANDARDS: ASTM C876, RILEM TC 154-EMC, DGZFP B3,
SIA 2006, UNI 10174, JGJ/T 152, JSCE E 601
This instrument is the direct successor to the Canin and it is the
most advanced corrosion detection device in the market. Consists
in a non-destructive method to determine the corrosion of the
reinforcement bars.
Same as C396N model, but with the accessories to detect corrosion
and without the accessories to measure concrete cover and rebar
location.
Supplied complete with rod electrode.
Memory:
internal 8 GB flash memory
Regional settings: metric and imperial units and multi-language
and timezone supported
Power input: 12 V ± 25 % / 1.5 A
Battery:
3.6 V, 14 Ah
Battery lifetime: > 8h (in standard operating mode)
Humidity:
< 95 % RH, non condensing
Operating temperature: -10 °C to +50 °C
IP classification: touchscreen IP54, universal probe IP67
Voltage measuring range: -1000 to + 1000 mV
Voltage resolution: 1 mV
Impedance:
100 MΩ
Sampling rate: 900 Hz
Dimensions:
250x162x62 mm
Weight:
1600 g approx
C412-01
DIGITAL RESISTIVITY 2-PROBE ARRAY METER
Used for assessing the probable rate of corrosion in reinforcing bars
with the electric resistivity measurement method.
A highly permeable concrete has a high conductivity with reduced
electrical resistance. The knowledge of the electrical resistance of
a concrete allows to measure the possible rate of corrosion of steel
reinforced bars.
The test is simple to perform and requires only two 6.5 mm
diameter holes drilled to a depth of 8 mm. Inject a small amount of
conductive gel into each hole and insert the probes. The resistivity
value is immediately displayed.
- Measuring range: 0.5 to 20 kΩ cm, with 0.1 kΩ resolution.
- 2-probe array spacing: 5 cm
- Display: LCD 4 ¼ digit
- Battery operated with 100 hours operating time
The instrument is supplied complete with drill bit, gel, template,
accessories, carrying case.
Dimensions: 400x270x130 mm
Total weight: 4 kg
C411N
Note: Possibility to upgrade the Profometer Corrosion C411N
to Profometer PM-600 C396N for both corrosion and
cover meter functions with the KIT below.
C396-01N
UPGRADE KIT TO PROFOMETER CORROSION
Universal probe with ruggedized cart, probe cable 1.5 m, software
upgrade to cover meter.
Technical details: see C396N.
C412-01
C414
COR MAP-HALF CELL METHOD
STANDARDS: ASTM C876 | BS 1881:201 | UNI 9535
A simple method for identifying areas of probable rebar corrosion in
concrete structures.
Detachable electrode extension pieces (41 cm long), facilitate
measurements in hard to reach locations.
High impedance digital meter is designed for tough field conditions.
Reference electrode, including copper sulphate reservoir.
Easy to use, supplied complete.
C396-01N
C414 complete set