Matest catalogue 2018

376
SECTION C | CONCRETE
C410
WINDSOR HP PROBE DIGITAL SYSTEM
STANDARDS: ASTM C803 | BS 1881:207 | ACI 347
To evaluate the compressive strength of concrete in place with
the penetration method. Non destructive test. It is fast, accurate
and simple to perform. The five-minute test does not weaken the
structure. Comparison between test results using this method and
destructive tests shows a variance normally within 3% from each
other. The method requires a pistol-like device which is loaded with
a small explosive charge and metal probe.The charge is precisely
measured to give a consistent firing force. By pulling the trigger the
probe is fired into the concrete.
C410
Standard equipment consist of:
- driven unit
- digital measuring unit with memory for data storage to PC unloading
- accessories and carrying case.
Probes and power charges are not included and must be ordered
separately.
Dimensions:
500x400x200 mm
Weight: 16 kg approx.
ACCESSORIES
C410 with case and accessories
C410-01 SILVER PROBES used for high performance concrete
with strength up to 17000 PSI (110 MPa).
Complete with probes and power loads.
Pack of 75 probe Kit.
C410-02 GOLDEN PROBES recommended for light weight concrete.
Complete with probes and power loads.
Pack of 75 probe kit.
C410-10N
PENETRATION PIN RESISTANCE DETECTOR
PENETRATION RESISTANCE
STANDARD: ASTM C803
This portable instrument is used to measure the resistance of
materials in situ for new or existing constructions. The operating
principle which the instrument is based is the capacity to nail a
pin into the surface of the material, since the penetration depth is
inversely proportional to compressive strength is easy to determine
the material resistence. The unit measures compression strength
of concrete and mortar in situ with accuracy and speed. It is a safe
tool that uses a mechanism equipped with a calibrated spring to
insert a steel nail into the material to be investigated. The depth
of penetration of the nail is measured and correlated with specific
curves to the compression strength of the test material. The removable
small section nail facilitates the use of the instrument and the
correct execution of the test.
Penetration resistance: 800 ± 8 N
Shot power: 20 ± 1 mm
Digital measuring gauge: 20 ± 0.01 mm
Nail dimensions: 3.5 mm diameter, 40 mm long
Supplied complete with 20 penetration nails, a little pump, a tightening
key, a load lever, a carrying case.
Dimensions: 420x310x150 mm
Weight: 8 kg approx.
SPARE
C410-11 Penetration nails (pack of 20pcs).
C410-10N
C403-10
DEEP SCANNING METAL DETECTOR UP TO 150 MM
This locator finds and scans, through solid concrete, steel rebars
and metallic materials like pipes, electric cables, junction boxes,
metal studs and frames up to 150mm deep.
It scans and differentiates steel rebars from other metallic materials
like copper pipes.
It differentiates magnetic metals from non magnetic ones.
This detector is an essential device for building contractors, remodelers,
electricians, plumbers.
Accuracy: rebars or pipes 14mm dia. with minimum grid space of
152mm are scanned within 13mm tolerance.
Depth: 152 ± 25mm
N° 1 alkaline battery 9V (not included)
for one year use.
Dimensions: 250x110x62 mm
Weight: 300 g approx.
C403-10