Matest catalogue 2018

338
SECTION C | CONCRETE
CONCRETE FLOW TABLE
STANDARD: ASTM C124
Used to determine the flow of concrete. The apparatus consists of a flow table, stainless steel flow mould, tamping bar.
MODELS
C208
FLOW TABLE
Hand-operated by crack handle.
Table diameter 762 mm
Weight: 100 kg approx.
C208-01 MOTORIZATION KIT to be connected to the flow table
mod. C208 and to get it automatic.
Complete with separate control panel and automatic
digital drops counter.
Power Supply: 230V 1ph 50Hz 750W
Weight: 15 kg approx.
C216
FOUR CHANNELS THERMOMETER
K-TYPE THERMOCOUPLE
NEW
Used to automatically measure and store the temperature of concrete
casting during the curing phase.
- The thermometer is provided with four inputs to connect separately
four K-type thermocouple probes.
- It can measure and store up to four simultaneous different points
at selectable sampling intervals from 1 to 3600 seconds.
- Measuring range: from -100 °C to 1370 °C
- Resolution: 0.1 °C
- Reading selectable: °C and °F
- Display size: 52x38 mm with green backlight (ON/OFF)
- SD memory card capacity 8Gb, USB/SD adapter
- Microcomputer circuit provides intelligent function and high accuracy.
- Real time SD memory and Datalogger, built-in Clock and Calendar,
real time data recorder.
- Innovation and easy operation, after tests execution, just take
away the SD card from the meter and plug into the PC; it down
load all the measured values and the user can make the further
data or graphic analysis.
- Automatic temperature compensation and linear compensation for
the full range.
- Auto power off if any button is not pressed within 10 minutes.
- Operating conditions: 0 to 50 °C and less than 85% R.H.
Supplied complete with: 50 meters coil K-type thermocouple,
set of 4 probes with male connectors, USB/SD adapter, SD
card 8Gb, batteries, carrying case.
C208
C208-01
C214
CEMENTOMETER
For the rapid determination of moisture content in wet cement and
concrete.
Fast and easy to use; simply insert the prongs into the material
being tested,
Accurate and instantaneous readings, digital portable meter.
Ratio range: 0.35 to 0.70 water/cement.
The unit can store over 150 readings.
Data can be recalled via RS-232 interface to using WIN98 and
above.
Power: 4AA Batteries
Weight: 2 kg approx.
C214-01
CEMENTOMETER
Same to mod. C214 but with ratio range: 0.25 to 0.5 for low water
cement ranges
C214
Power supply: 6 x 1.5V battery.
Dimensions (of the thermometer):
177x68x45 mm
Weight: 500 g approx.
SPARE
C216-01 K-Type
Thermocouple coil (50 meters)
C216