DOC-20230111-WA0038.

FRONT ATTACHMENT / Front Attachment
CAUTION: Front attachment weight:1110 kg
(2450 Ib)
4. Attach a wire rope to the boom to take up slack of
the wire rope.
5. Disconnect the work light connector and all hoses.
Cap the disconnected hoses. Install plug to each
pipe adapter at boom side.
: 27 mm
Plug (boom): 13/16-16UNF
Plug (boom cylinder): 13/16-16UN
W102-04-01-007
6. Loosen bolts (5) (2 used ) to remove plate (6),
then pull boom foot pin (7) out by prying with a
crowbar.
: 24 mm
NOTE: If boom foot pin (7) can not be removed,
pull them out by using special tool (ST
1953) and bolts holes (M12, pitch 1.75).
Screw Bar: M12 Pitch 1.75 Length 491mm
or more
7
(Special Tool
ST 1953)
5
6
7
Bolt Hole
W197-04-01-002
Screw Bar
W102-04-01-008
W191-04-01-004
CAUTION: Front attachment weight:
1110 kg (2450 Ib)
7. Lift the front attachment by crane to remove it
from the base machine.
Remove the thrust plates (4 used) from both sides
of the boom foot.
W102-04-01-007
W4-1-3