DOC-20230111-WA0038.

UPPERSTRUCTURE / Cab
9. Disconnect connector (30) of work light harness
(29) at right rear side from the cab. Loosen clips
(31) (2 used). Pass the work light harness at the
main frame side through to draw the harness out
by the clips.
NOTE: No need to remove the work light on the
cab, work light harness (29) of the cab side
and clips (31) (8 used).
Work Light
29
30
31
W1CC-02-01-002
10. Remove bolts (34) (6 used), spring washers (33)
(6 used), plane washers (32) (6 used). Then remove
under cover (35).
: 17 mm
35
32
33
34
W1CC-02-07-003
11. Draw out work light harness (29) at the main
frame side from the hole where under cover (35)
has been removed.
NOTE: Wind the work light harness passing
through the cab into a ball near the floor
plate hole, and secure it.
29
Floor Plate Hole
W1CC-02-01-001
W2-1-3