DOC-20230111-WA0038.

Install upper front glass as follows
UPPERSTRUCTURE / Cab
1. The glass is adhered with mounting rubber. Draw
the mounting rubber and secure to the cab mounting
surface. (All around the glass)
2. Adhere seal (1) to the lower side the upper front
glass with POS seal.
Adhere both right and left ends (the part turning
thicker after bringing together) of seal (1) with adhesive
POS seal to secure them together.
Adhere the lip in the center of seal (1) with POS
seal. No visible bending or folds can be found.
Adhered with
Mounting Rubber
(All Around the
Glass)
Upper Glass
Frame
NOTE: POS seal:
TOSHIBA SILONCON POS Seal (black)
Tube adhesive in glue form
IMPORTANT: The glass and mounting rubber
should be adhered with special adhesive.
Failure to do so, may result
in the glass dropping out. Therefore,
if the glass needs to be replaced, replace
the glass and mounting rubber
as a unit.
Upper front glass is arched-fringed
type. If this glass needs to be replaced,
contact with the nearest HI-
TACHI Office to replace it as a unit.
Lower Glass
Upper Glass
1
Adhere POS
Seal
POS Seal
1 1
Lower Glass
Lower Glass
W1SE-02-01-047
W2-1-19