DOC-20230111-WA0038.

FRONT ATTACHMENT / Cylinder
Remove Bucket Cylinder
CAUTION: Prevent personal injury. Metal debris
may fly when a hammer is used to remove
pins. Be sure to wear necessary protections,
such as goggles, hard-hat, etc.
1
1. Lay wooden blocks under the arm (2) tip and in
the clearance between the arm (2) top surface
and bucket cylinder (1).
2
Wooden
Blocks
IMPORTANT: Before removing pin (6), secure the
links with wires to prevent the links
from falling it.
2. Remove ring (5) and stopper pin (3) to remove pin
(6).
Remove thrust plates (4) from the mating faces
between the links and the bucket cylinder (1) rod.
3
4
1
W554-04-02-006
5
6
3. Bind rod (7) of bucket cylinder (1) with wire so that
cylinder rod (7) is not extended.
7
1
W158-04-02-005
4. Disconnect hoses (11) (2 used) from the bottom
of bucket cylinder (1). Cap the disconnected hose
(11) ends.
: 27 mm
11
CAUTION: Bucket cylinder weight: 57 kg
(126 Ib)
5. Hold bucket cylinder (1) by crane using wire rope.
Remove ring (12) and stopper pin(8).
Drive pin (10) out with a bar and a hammer to remove
thrust plate (9). Hoist bucket cylinder (1)
and remove it.
1
Wire
9
8 10
W102-04-02-005
12
11
W158-04-02-007
W4-2-2