DOC-20230111-WA0038.

FRONT ATTACHMENT / Cylinder
Remove Arm Cylinder
1 2
CAUTION: Prevent personal injury. Metal debris
may fly when a hammer is used to remove
pins. Be sure to wear necessary protections,
such as goggles, hard hat, etc.
1. Place a wooden block on the top surface of boom
(2) to support arm cylinder (1).
2. Remove ring (6) and stopper pin (3). Drive pin (5)
out with a bar and a hammer.
Remove thrust plates (4) from the mating faces
between the arm and the arm cylinder (1) rod.
NOTE: If it is difficult to remove pin (5), lift the
boom slightly to remove the pin.
Wooden Block
4
3 5
W102-04-02-009
3. Bind the cylinder rod with wire so that the arm cylinder
(1) rod is not extended.
6
1
W158-04-02-009
Wire
W102-04-02-013
7
4. Disconnect hoses (7) (2 used) from the bottom of
arm cylinder (1). Disconnect grease hose (8) from
the work light side of the boom and the cylinder
tube side of the arm cylinder. Cap the disconnected
hoses ends.
: 17 mm, 19 mm, 27 mm
1
8
W102-04-02-014
W4-2-4