DOC-20230111-WA0038.

11. Align the holes on piston rod (1) and piston (14).
Install steel ball (15), then tighten set screw (16).
The set screw should be crimped with punch in 2
places after it is tightened.
:8 mm
: 31.5±5.9 N⋅m
(3.2±0.6 kgf⋅m, 23±4.3 lbf⋅ft)
IMPORTANT: Be sure to keep piston rod (1) aligning
with center of cylinder tube (24)
when inserting in order to avoid
damaging the piston rings.
12. Securely place cylinder tube (24) on a workbench,
insert the piston rod (1) assembly into the cylinder
tube .
13. Tighten cylinder head (6) to cylinder tube (24)
using R wrench (ST 3221). Fold the detents to
lock cylinder head (6).
: 570±127 N⋅m
(58±13 kgf⋅m, 420±94 lbf⋅ft)
FRONT ATTACHMENT / Cylinder
W4-2-29