Audio Interface / Mobile Preamp - zZounds.com
Audio Interface / Mobile Preamp - zZounds.com
Audio Interface / Mobile Preamp - zZounds.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Tutorials<br />
2 - Basic Multitrack Recording<br />
This tutorial assumes you’re using a single input or a pair of inputs. For more<br />
advanced recording, refer to the Cubase LE 4 manual.<br />
Add an <strong>Audio</strong> Track<br />
1. From the Cubase LE 4 menu bar, select Project, Add Track, <strong>Audio</strong>. A pop-up<br />
dialog box appears, asking you if you would like to add a mono or stereo<br />
track. Choose a mono track for now. After making your selection, click OK. A<br />
new audio track is added to the project window.<br />
Inspector button<br />
Track Input Routing Monitor Button<br />
Select Mono (or Stereo)<br />
2. The Track Input Routing field is where you connect the Tracker Pre inputs to<br />
the track. Left-Stereo In will appear in the Track Input field. (You can change<br />
this to “Right-Stereo In” if you wish.)<br />
3. Make sure the Monitor button is OFF. You will be monitoring the input<br />
through the Tracker Pre.<br />
4. Press the Direct Monitor button on your Tracker Pre USB 2.0. If you are<br />
recording a mono track, set Direct Monitor to Mono by pressing the Direct<br />
Monitor button again.<br />
Get Ready To Record<br />
5. Plug in your instrument or microphone into the 1L (left) input and set the<br />
input gain control for a good signal level. The green -12 signal LED should<br />
<strong>com</strong>e on, but the clip LED should never <strong>com</strong>e on.<br />
6. You should be hearing your instrument or microphone through your monitor<br />
speakers or headphones. If not, go back to steps 4 and 5.<br />
The Direct Monitor Button<br />
routes the inputs directly<br />
to the outputs.<br />
TRACKERpre Reference Manual 21