CCNA 3 Labs and Study Guide - BINARYBB.INFO – @jagalbraith

482 Switching Basics and Intermediate Routing CCNA 3 Labs and Study Guide
C 10.10.1.0 is directly connected, Serial0/1
C 192.168.2.0/24 is directly connected, Loopback0
S* 0.0.0.0/0 is directly connected, Serial0/1
Router2#ping 172.16.2.33
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.2.33, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 40/44/60 ms
Router2#ping 172.30.2.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.30.2.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 32/33/36 ms
Router2#show version
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.3(17a), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Mon 12-Dec-05 14:12 by evmiller
Image text-base: 0x80008098, data-base: 0x81A33618
ROM: System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-J1S3-M), Version 12.3(17a), RELEASE SOFTWARE (fc2)
Router2 uptime is 43 minutes
System returned to ROM by power-on
System image file is "flash:c2600-j1s3-mz.123-17a.bin"
cisco 2621XM (MPC860P) processor (revision 0x100) with 118784K/12288K bytes of m
emory.
Processor board ID JAE07420G4S (1562611187)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
TN3270 Emulation software.
2 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
49152K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102